A contemporary bathroom vanity can have a nice and modern look that is unprofitable bathroom vanity has a very important place in the bathroom design A nice looking modern vanity can lift the overall outlook of your bathroom You can install a contemporary bathroom vanity yourself with careful planning and Preparations by following these steps
Step 1 Connect the water pipes
If you have an old bathroom vanity, you must remove it before installing it. Turn off the water at the mains. Then tap the tap to drain the rest of the water. Use a wrench to disconnect the water pipes from the sink, drain and tap the tap. Take the contemporary bathroom vanity countertop by removing the screws in the corners of the countertop. The vanity should not get out easily because it is glue. Use a tip to remove. Now remove the screws from the back of the bathroom makeup.
12 Photos Gallery of: How to Install a Contemporary Bathroom Vanity
Step 2 Check floor and wall for damage
Once you have removed the old contemporary bathroom vanity, check the floor and wall for damage. Common problems rudder or moisture on the wall or the floor repair damage immediately. Measure the width of the tube and mark it on the back of the bathroom vanity. Drill a hole somewhere on the marked line. Slide the stitching inside and cut along the marked line. Check that the pipes slide through the holes easily.
Step 3 Find Studs on the wall
To screw the modern bathroom vanity to the wall. Slide vanity in place against wall Check floor plan If floor is not level, you can use shims to smooth out vanity. For most contemporary bathroom vanity, the crane must be fixed in place before vanity is screwed into the wall. If so, you can fix the crane with silicone
Step 4 Attach Vanity to the wall
Screw vanity on the wall and spread glue on all 4 sides of vanity. Place the worktop and screw. Connect the pipe system and your contemporary bathroom vanity is ready to use.